Tolerance Stack-Up Analysis (for Plus & Minus and Geometric Tolerancing)

5.6 Hours of Lecture from the two and a half day lecture on Tolerance Stack-Up Analysis
#1 THE BASICS
#2 STACK-UP ANALYSIS OF AN ELEVEN PART ASSEMBLY USING PLUS
AND MINUS TOLERANCING
#4 ASSEMBLIES WITH PLUS AND MINUS TOLERANCES
#5 FLOATING FASTENER FIVE PART ASSEMBLY ANALYSIS
#6 FIXED FASTENER ASSEMBLIES
#7 A RAIL ASSEMBLY
#8 SINGLE-PART A...

US$ 991.20

Tolerance Stack-Up Analysis : Chapter 1

THE BASICS
Topics
•Where to begin a stack
•Designating positive and negative routes
•What are you calculating?
•What dimensions are factors
•How to push the parts to create the worst case
•Which geometric tolerances are and are not factors
•Finding the mean
•Calculating boundaries for GD&T, MMC, LMC and RFS Material Condition m...

From US$ 144.55

Tolerance Stack-Up Analysis : Chapter 11

THE THEORY OF STATISTICAL PROBABILITY
Topics
•Gaussian Frequency Curve
•Standard Deviations
•Plus or Minus 3 Sigma
•Root Sum Square Formula
•Steps to Calculate and Apply Statistical Tolerances
•Statistical Tolerancing Applied to Plus and Minus Toleranced Assemblies
•Statistical Tolerancing Applied to Geometric Toleranced Assemblies

From US$ 91.45
  • (1)

Tolerance Stack-Up Analysis : Chapter 2

STACK-UP ANALYSIS OF AN ELEVEN PART ASSEMBLY USING PLUS
AND MINUS TOLERANCING
Topics
•The calculations
•The loop analysis chart
•The numbers analysis chart
•Finding MIN and MAX gaps

From US$ 44.25

Tolerance Stack-Up Analysis : Chapter 5

FLOATING FASTENER FIVE PART ASSEMBLY ANALYSIS
Topics
•Resultant conditions
•Virtual conditions
•Inner and outer boundaries
•Mean boundaries
•Converting to radii
•Mixing widths and diameters
•Complex loop analyses with geometric dimensioning and tolerancing

From US$ 100.30

Tolerance Stack-Up Analysis : Chapter 6

FIXED FASTENER ASSEMBLIES
Topics
•Calculating overall minimum and maximum assembly dimensions
•Mixing slots, tabs, holes and shafts
•Calculating minimum and maximum gaps within the assembly
•Projected tolerance zones and total runout as factors
•Determining if geometric tolerances are a factor
•Ruling out features and patterns as factors

From US$ 112.10

Tolerance Stack-Up Analysis : Chapter 7

A RAIL ASSEMBLY
Topics
•Threaded features
•Multiple geometric controls
•Projected tolerance zones
•How to tell a right answer from a wrong answer
•Theoretically vs. physically worst case possibilities
•When logic becomes an integral step
•Calculating interference
•Factoring in assembly conditions
•Maximum wall thickne...

From US$ 91.45

Tolerance Stack-Up Analysis : Chapter 8

SINGLE-PART ANALYSIS
Topics
•Two-single segment positional controls
•Creating envelopes of perfect orientation at MMC
•Switching datum reference frames and accumulating geometric tolerances
•Datum features at MMC (pattern shift)
•Flatness
•Envelopes of perfect form at MMC
•Datum planes vs. datum features
•Profile tolerances

From US$ 177.00

Tolerance Stack-Up Analysis : Chapter 9

FIVE PART ROTATING ASSEMBLY ANALYSIS
Topics
•Position
•Perpendicularity
•Parallelism
•Profile
•Flatness
•Threaded holes with projected tolerance zones
•Mounted screws
•Part to part analysis (from two parts to an infinite number of parts
•Positional coaxiality
•Runout
•Total runout
•Simplifying a co...

From US$ 147.50